NOTE
Check transmission fluid with the motorcycle at room temperature.
| 1. | Park on level ground on the jiffy stand. | |
| 2. | See Figure 1. Remove transmission lubricant dipstick. Wipe dipstick clean. | |
| 3. | Insert dipstick into transmission. Thread dipstick in until O-ring makes contact with case. Do not tighten. | |
| 4. | See Figure 2. Remove dipstick. Check lubricant level on dipstick. | |
NOTICE Mixing mineral-based lubricants with SYN-3 in the transmission can damage the transmission. (00452b) | ||
| 5. | The level should be between the A and F marks. Add only enough lubricant to bring level to between the A mark and the F mark. Refer to Table 1. | |
| 6. | Install dipstick. Tighten to 2.8–8.5 N·m (25–75 in-lbs). |
Figure 1. Transmission Dipstick Location
| 1 | Add (A) |
| 2 | Full (F) |
Figure 2. Transmission Dipstick Lubricant Level
Table 1. Recommended Lubricant
LUBRICANT | REFILL QUANTITY * |
|---|---|
FORMULA+ TRANSMISSION AND PRIMARY CHAIN LUBRICANT or SCREAMIN' EAGLE SYN3 FULL SYNTHETIC MOTORCYCLE LUBRICANT 20W50 | 0.83 L (28 fl oz) |
*Approximate. Check and add as needed to bring level within
specification. | |