1. See Figure 1. Remove snap plug (1) on top of headlamp bracket (2) by inserting a small screwdriver through hole on left side under headlamp bracket and pushing up.
2. Loosen headlamp clamp nut (3).
3. Tilt headlamp up or down to aim it at horizontal line. At same time, turn it right or left to aim beam straight ahead.
4. Tighten headlamp clamp nut to 14–27 N·m (120–240 in-lbs) after lamp is properly positioned.
5. Install snap plug-in headlamp bracket.
1Snap plug
2Headlamp bracket
3Clamp nut
Figure 1. Headlamp Adjustment: FXDL