Special Tools
| Description | Part Number | Qty. |
|---|---|---|
| OIL FILTER WRENCH | HD-42311 | 1 |
| OIL FILTER WRENCH | HD-44067 | 1 |
NOTICE
Do not switch lubricant brands indiscriminately because some lubricants interact chemically when mixed. Use of inferior lubricants can damage the engine. (00184a)
WARNINGBe sure that no lubricants or fluids get on tires, wheels or brakes when changing fluid. Traction can be adversely affected, which could result in loss of control of the motorcycle and death or serious injury. (00047d)
| 1. | Ride motorcycle until engine is warmed up to normal operating temperature. | |
| 2. | See Maintenance and Lubrication → Checking and Adding Oil → Checking Engine Oil Level. Remove the cap to remove the oil filler plug/dipstick. | |
| 3. | See Figure 1. Remove the engine oil drain plug with O-ring. Allow oil to completely drain into a suitable container. | |
NOTICE Use Harley-Davidson oil filter wrench for filter removal. This tool can prevent damage to crankshaft position sensor and/or sensor cable. (00192b) | ||
| 4. | Remove the oil filter using the OIL FILTER WRENCH (Part Number:HD-42311) or OIL FILTER WRENCH (Part Number:HD-44067). Clean the oil filter mount flange of any old gasket material. NOTE Dispose of oil and oil filter in accordance with local regulations. | |
| 5. | See Figure 2. Lube the gasket on new oil filter (Part No. 63798-99A Chrome or Part No. 63731-99A Black) with engine oil and install new filter. Hand-tighten oil filter one-half to three-quarters of a turn after gasket contacts filter mounting surface. | |
| 6. | See Figure 1. Install oil drain plug. a. Inspect O-ring for tears or damage. Replace if required. Wipe any foreign material from plug. b. Install O-ring and drain plug and tighten to 19–28.5 N·m (14–21 ft-lbs). | |
NOTICE Do not overfill oil. Doing so can result in oil carryover to the air cleaner leading to equipment damage and/or equipment malfunction. (00190b) | ||
| 7. | Refer to Maintenance and Lubrication → Engine Lubrication → Recommended Engine Oils. Fill oil pan with the correct amount of oil. Use the proper grade of oil for the lowest temperature expected before next oil change. Use 2.4 L (2.5 qt) of engine oil for a capacity refill. | |
| 8. | Check engine oil level using COLD CHECK procedure. | |
| 9. | Start engine and carefully check for oil leaks around drain plug and oil filter. | |
| 10. | Check engine oil level using HOT CHECK procedure. |
Figure 1. Engine Oil Drain Plug (Oil Pan Under Transmission, View From Left Side of
Vehicle)
| 1 | Thin film of oil ONLY |
| 2 | Oil filter |
| 3 | Mounting plate |
Figure 2. Applying Thin Oil Film