There are two ways to disarm the system:
NOTE
Do not forget to enter a personal code for security system vehicles. If a code is not assigned and the key fob is lost or damaged while the vehicle is armed, the security system module must be replaced. Refer to H-D Factory Security System → Personal Code → Programming a Personal Code for personal code setup.
Using Key Fob
See H-D Factory Security System → Arming The System → Key Fob. Quickly press the key fob button twice. The system will respond with one turn signal flash.
NOTE
  • Disarming function may require practice. The key fob button must be pressed twice within 1.5 seconds to send the disarm command. The action is very similar to double-clicking a computer mouse. Light quick taps work best; very hard or very slow taps are less likely to work.
  • If the system is remotely disarmed (with the key fob) but the ignition key is not turned ON within 30 seconds, the system will rearm itself when auto-arming is enabled.
Using Personal Code
Enter the five digit personal code you have chosen using the left and right turn signal switches. For complete procedure refer to Table 1. To create a personal code, refer to H-D Factory Security System → Personal Code → Programming a Personal Code.
NOTE
If you make an error while disarming the security system using the personal code, the alarm will activate for 30 seconds after the last digit is entered. After a failed attempt, the security lamp will flash once every second for 10 minutes. During this time, the vehicle will not accept any attempt to enter a personal code.
Table 1. Entering a Personal Code to Disarm Security System
STEP
NO.
ACTION
WAIT FOR CONFIRMATION
NOTES
NOTE: The left turn signal switch is used for code number entry and the right turn signal is used as the "enter" key.
1
Know your 5 digit personal code
2
Turn IGN key to ACC
3
Hold both turn switches in until confirmation
Security lamp blinks at fast rate
4
Enter first digit of code (a) by pressing left turn switch a times
5
Press right turn switch 1 time
Serves as enter key for first digit
6
Enter second digit of code (b) by pressing left turn switch b times
7
Press right turn switch 1 time
Serves as enter key for second digit
8
Enter third digit of code (c) by pressing left turn switch c times
9
Press right turn switch 1 time
Serves as enter key for third digit
10
Enter fourth digit of code (d) by pressing left turn switch d times
11
Press right turn switch 1 time
Serves as enter key for fourth digit
12
Enter fifth digit of code (e) by pressing left turn switch e times
13
Press right turn switch 1 time
Security lamp stops blinking
System is disarmed. You may use the vehicle or program another key fob.