Ignition/Fork Lock Key
The ignition key locks the ignition switch to prevent unauthorized use of theft of your motorcycle. The same key also works in the fork lock to prevent unauthorized movement of your motorcycle.
See Figure 1. If lost, a Harley-Davidson dealer can replace the key based on the unique key number. The key number (2) is stamped on the top of the key under the plastic cover (1). Record your key number on the line provided on the Personal Information and Dealer Information page in the front of this Owner's Manual.
| 1 | Cover |
| 2 | Key number |
Figure 1. Ignition/Fork Lock Key
Ignition Switch
WARNINGThe automatic-on headlamp feature provides increased visibility of the rider to other motorists. Be sure headlamp is on at all times. Poor visibility of rider to other motorists can result in death or serious injury. (00030b)
The ignition switch controls the electrical functions. Refer to Table 1.
NOTICE
Protect your vehicle against theft. Failure to lock the motorcycle after parking could result in theft and/or equipment damage. (00151b)
WARNINGDo not operate vehicle with forks locked. Locking the forks restricts the vehicle's turning ability, which could result in death or serious injury. (00035a)
NOTICE
Do not lubricate barrel locks with petroleum based lubricants or graphite. Inoperative locks may result. (00152a)
NOTE
- The instrument lamps and headlamps are illuminated when the switch is in the IGN position as required by law in some localities. Refer to Table 1.
- Remove the ignition key from the ignition lock while operating the motorcycle. If you do not remove the key, it can fall out.
- Leaving the motorcycle in ACC for an extended amount of time can discharge the battery. If in ACC, the motorcycle will be automatically turned OFF after two hours to prevent battery from complete discharge. To resume normal operation turn the ignition switch back to OFF and then to the desired position.
Table 1. Ignition Switch Positions
SWITCH POSITION | FUNCTION |
|---|---|
OFF | Ignition, lamps and accessories are off. |
ACCESSORY (ACC)* | Accessories are on. Hazard warning flashers can be operated. Instrument
lamps are on. The headlamp switch can be switched between high and low beam.
Brake lamp and horn can be activated. |
IGNITION (IGN)* | Ignition, lamps and accessories are on. |
*International models have an additional function - position lamp and tail
lamp are also on. | |
All Models Except FXDL
See Figure 2. The ignition switch is on the instrument panel on top of the tank.
Unlock: To unlock the switch, insert key and turn clockwise to unlock position.
Operate: Rotate switch to select the ACC or IGN position. Refer to Table 1.
Lock: The switch can be locked in the OFF or ACC position. To lock the switch, raise the switch cover, insert key, and turn counterclockwise to the lock position.
NOTICE
Turn the ignition switch to the OFF position before locking the motorcycle. Leaving the switch in the ACC position will keep the instrument lights on and result in a discharged battery. (00492b)
| 1 | Lock |
| 2 | Unlock |
| 3 | Open switch cover |
| 4 | ACC (Accessory) |
| 5 | OFF |
| 6 | IGN (Ignition) |
Figure 2. Ignition Switch: All Models Except FXDL, FXDLS
FXDL
See Figure 3. The ignition switch is on the left side of the vehicle between the engine cylinders.
Unlock: Insert key and turn clockwise to unlock the thumb lever. Remove the key from ignition switch before operating motorcycle.
Operate: Use the thumb lever to select the ACC or IGN positions. For ignition switch functions, refer to Table 1.
Lock: Turn the thumb lever to OFF. Insert the key and turn counterclockwise to lock the thumb lever. Remove the key.
| 1 | Lock |
| 2 | Unlock |
| 3 | IGN (Ignition) |
| 4 | ACC (Accessory) |
| 5 | OFF |
| 6 | Thumb lever |
Figure 3. Ignition Switch: FXDL