Disconnection and Removal
WARNING
Disconnect negative (-) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00049a)
  1. On FXCWC model, lift the rear of the seat toward fuel tank. For all other models, remove the seat. See Maintenance and Lubrication → Seats and follow procedure for the appropriate model.
  2. See Figure 1. On FXCWC model, lift battery cover from frame and remove.
  3. See Figure 2. On FLSTSB model, remove frame fairing.
    1. Remove thumbscrew from frame fairing.
    2. Lift rear of frame fairing. Raise fairing over the seat spring mounting pins.
    3. Pull fairing to the rear and remove.
  4. If equipped with security system siren, turn the ignition switch ON with the hands-free fob present to disarm the security system.
  5. See Figure 3. Loosen bolt and remove battery negative cable (black) from battery negative (-) terminal.
  6. Loosen bolt and remove battery positive cable (red) from battery positive (+) terminal.
  7. Lift battery from battery box within oil tank cavity.
Installation and Connection
NOTICE
Do not over-tighten bolts on battery terminals. Use recommended torque values. Over-tightening battery terminal bolts could result in damage to battery terminals. (00216a)
WARNING
Connect positive (+) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00068a)
WARNING
Do not allow positive (+) battery cable to contact ground with negative (-) cable connected. Resulting sparks can cause a battery explosion, which could result in death or serious injury. (00069a)
1. Place the fully charged battery into the battery box located within oil tank cavity, terminal side forward.
2. Attach battery positive cable (+) (red) to battery positive (+) terminal.
3. Tighten fastener to 6.8–7.9 N·m (60–70 in-lbs).
4. Attach battery negative cable (black) to battery negative (-) terminal.
5. Tighten fastener to 6.8–7.9 N·m (60–70 in-lbs).
NOTICE
Keep battery clean and lightly coat terminals with petroleum jelly to prevent corrosion. Failure to do so could result in damage to battery terminals. (00217a)
6. Apply a light coat of petroleum jelly or corrosion retardant material to both battery terminals.
7. See Figure 1. On FXCWC model, insert battery cover tabs into frame.
8. See Figure 2. On FLSTSB model, install frame fairing.
a. Insert fairing tab in frame bracket at the base of the fuel tank.
b. Lower fairing holes over the seat spring mounting pins.
c. Hand-tighten the thumbscrew.
WARNING
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)
9. On FXCWC model, lower seat and press down to engage locating pins. On all other models, install seat. See Maintenance and Lubrication → Seats and follow procedure for the appropriate model.
Figure 1. Battery Cover (Removal Slot Shown): FXCWC Models
1Frame fairing
2Thumbscrew
3Tab
4Seat spring mounting bracket
Figure 2. Frame Fairing: FLSTSB Models
1Positive (+) terminal
2Negative (-) terminal
Figure 3. Battery: Softail Models