| 1. | See Figure 1. Make certain ignition switch is turned off. | |
| 2. | Remove two screws and lens from base. NOTE For ease of bulb removal, the 4-Pin multilock connector can be removed from circuit board. | |
| 3. | Remove (pull) bulb assembly from lens. Remove bulb from socket. | |
| 4. | Coat base of new bulb with ELECTRICAL CONTACT GREASE (Part No. 99861-90). Install new bulb in socket. | |
| 5. | Install (push) bulb assembly to lens. | |
| 6. | If removed connect 4-Pin multilock connector to circuit board. | |
| 7. | Install lens to base with two screws. Tighten screws to 2.3–2.7 N·m (20–24 in-lbs). | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 8. | Turn ignition on and test for proper tail lamp operation. |
| 1 | Lens |
| 2 | Base |
| 3 | 4-pin multilock connector |
| 4 | Bulb socket |
Figure 1. Tail Lamp Assembly