| 1. | See Figure 1. Insert a coin or the blade of a small screwdriver into the notch at the bottom of the lens cap. Carefully twist until the lens cap pops out of the lamp housing. | |
| 2. | Push bulb in and rotate counterclockwise. Pull bulb from socket. | |
| 3. | Inspect condition of electrical contacts in socket. If necessary, clean with a small wire brush and electrical contact cleaner. | |
| 4. | Coat base of new bulb with ELECTRICAL CONTACT GREASE (Part No. 99861-90). | |
| 5. | Align pins on bulb with pin guides in bulb socket. Push new bulb in and turn clockwise to lock in place. | |
| 6. | Snap lens cap back into the lamp holder. Rotate lens to position notch at bottom of lamp. | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 7. | Test turn signal operation. |
Figure 1. Lens Cap Notch