Rider Seat
The front of the rider seat is attached to the frame with a pivoting hinge. To open, pull back of rider seat up to release locating pins and pivot forward toward fuel tank. Nose of seat cushion may need to be pushed down to avoid catching on rear mount of console.
To close, rotate the rider seat back down into riding position ensuring that the locating pins properly engage their grommet seats.
Passenger Pillion Seat Deployment
A pillion seat, stored under the rider seat, can be deployed to accommodate a passenger.
NOTE
The pillion seat supports up to 90 kg (200 lb).
1Rider seat
2Passenger pillion
3Pillion support
Figure 1. Seats: FXCWC
Figure 2. Opening Rider Seat: FXCWC Models
  1. See Figure 2. Pull back of rider seat up to release locating pins and pivot forward toward fuel tank. Nose of seat cushion may need to be pushed down to avoid catching on rear mount of console.
Figure 3. Positioning the Pillion Support: FXCWC Models
  1. See Figure 3. Slide hinge pins of pillion support upward in side upright slots, then rotate pillion support approximately 180 degrees.
Figure 4. Pillion Support in Position: FXCWC Models
  1. See Figure 4. Push pillion support back down the slot so catch pin is fully engaged in bottom of side upright slots.
Figure 5. Removing Pillion From Rider Seat
  1. See Figure 5. Remove the pillion pad from the rider seat compartment.
  1. Rotate the rider seat back down into riding position ensuring that the locating pins properly engage their grommet seats and the slots between the back cushions fit around the support uprights.
  2. The pillion pad has two pins on the front; one is round (on the right side) and the other flat-keyed (on the left side). Insert the round, right-hand side into its pivot seat in the right side of the pillion support.
Figure 6. Inserting Pins Into Pillion Support: FXCWC Models
  1. See Figure 6. When the pillion pad is approximately vertical, the left side flat key can then be put into its pivot seat on the pillion support.
Figure 7. Pillion Latch Engaged: FXCWC Models
  1. See Figure 7. Rotate the pillion pad to its horizontal position. Apply slight pressure on the end until the pillion pad latch catches on the back of the pillion support.
Stowing the Passenger Pillion
To stow the passenger pillion, unlatch the pillion pad by pulling on the latch ring under the rear of the pillion pad and reverse the pillion seat deployment instructions.
NOTE
See Figure 5. When stowing the pillion pad back in the rider seat compartment of the rider seat, the padding should be up and the pull tab goes in first. When properly stowed, the pillion pad's keyed pivot will be visible when looking at the opening of the rider seat compartment as shown in Figure 2.