| 1. | See Figure 1. Make certain ignition switch is turned off. | |
| 2. | Remove three screws to detach the tail lamp assembly from base. | |
| 3. | Push bulb into socket and rotate one-quarter turn counterclockwise. Pull bulb from socket. | |
| 4. | Inspect condition of electrical contacts in socket. If necessary, clean with a small wire brush and electrical contact cleaner. | |
| 5. | Coat base of new bulb with ELECTRICAL CONTACT GREASE (Part No. 99861-90). | |
| 6. | Orient index pins on new bulb with pin guides inside bulb socket. Push bulb in and turn clockwise to lock in place. | |
| 7. | Install tail lamp assembly to base with three screws. Tighten screws to 2.3–2.7 N·m (20–24 in-lbs). | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 8. | Turn ignition on and test for proper tail lamp operation. |
| 1 | Screws (3) |
| 2 | Tail lamp assembly |
| 3 | Bulb |
Figure 1. Tail Lamp Assembly: Tombstone Style