Special Tools
| Description | Part Number | Qty. |
|---|---|---|
| OIL FILTER WRENCH | HD-44067 | 1 |
Oil filter is located on an oil filter mount in front of the engine.
NOTICE
Do not switch lubricant brands indiscriminately because some lubricants interact chemically when mixed. Use of inferior lubricants can damage the engine. (00184a)
WARNINGBe sure that no lubricants or fluids get on tires, wheels or brakes when changing fluid. Traction can be adversely affected, which could result in loss of control of the motorcycle and death or serious injury. (00047d)
Twin Cam 96B equipped vehicles require the premium oil filter (Part No. 63798-99A Chrome or Part No. 63731-99A Black).
- See Maintenance and Lubrication → Checking Oil Level: Softail Models → Oil Dipstick Location: FXCW (FXCW/FXCWC) or Maintenance and Lubrication → Checking Oil Level: Softail Models → Checking Oil Tank Level: Softail Models (all other models). On FXCW/FXCWC models, unscrew oil filler cap and remove. On other models, pull steadily on filler cap while moving plug back and forth to remove.
- See Figure 1. Remove engine oil drain plug with o-ring (2). Allow oil to completely drain into a suitable container.
| 1 | Frame connection for oil tank drain hose |
| 2 | Oil tank drain plug and o-ring |
Figure 1. Oil Tank Drain Plug: Softail Models
Figure 2. Oil Filter Wrench (Part No. HD-44067)
NOTICE
Use Harley-Davidson oil filter wrench for filter removal. This tool can prevent damage to crankshaft position sensor and/or sensor cable. (00192b)
NOTE
Dispose of oil and oil filter in accordance with local regulations.
| 1. | See Figure 2. Remove the oil filter using the OIL FILTER WRENCH (Part Number:HD-44067). Clean the oil filter mount flange of any old gasket material (surface should be smooth and free of any debris or old gasket material). | |
| 2. | Inspect o-ring for tears or damage. Replace if required. Wipe any foreign material from plug. | |
| 3. | Install o-ring and drain plug and tighten to 19–28.5 N·m (14–21 ft-lbs). | |
| 4. | See Figure 3. Apply a thin film of oil to gasket contact surface on mounting plate, gasket and new oil filter. | |
| 5. | Screw filter onto adapter until gasket contacts plate surface, then apply another 3/4-1 full turn. | |
| 6. | Fill oil tank with no more than 3.31 L (3.50 qt) of oil. Use the proper grade of oil for the lowest temperature expected before next oil change. | |
NOTICE Do not overfill oil. Doing so can result in oil carryover to the air cleaner leading to equipment damage and/or equipment malfunction. (00190b) | ||
| 7. | Install the filler cap. | |
| 8. | Start engine and carefully check for oil leaks around drain plug and oil filter. | |
| 9. | Check engine oil level. Install filler cap. |
| 1 | Thin oil film ONLY |
| 2 | Oil filter |
| 3 | Mounting plate |
Figure 3. Applying Thin Oil Film