Consumables
| Description | Part Number | Size |
|---|---|---|
| ELECTRICAL CONTACT GREASE | 99861-90 | 28 g (0.99 oz) |
| 1. | See Figure 1. Insert a coin or the blade of a small screwdriver into the notch at the bottom of the lens cap. Carefully twist until the lens cap pops out of the lamp housing. | |
| 2. | Push in bulb and rotate counterclockwise. Pull bulb from socket. | |
| 3. | Inspect condition of electrical contacts in socket. If necessary, clean with a small wire brush and electrical contact cleaner. | |
| 4. | Coat base of new bulb with ELECTRICAL CONTACT GREASE (99861-90). | |
| 5. | Orient index pins on new bulb with pin guides inside bulb socket. Push bulb in and turn clockwise to lock in place. | |
| 6. | Snap lens cap back into the lamp holder. Rotate lens to position notch at bottom of lamp. | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 7. | Turn ignition on and test for proper turn signal operation. |
NOTE
If the turn signal or running lamp will not light after replacing a bulb, check the wiring, the ground at the socket and/or the switch.
Figure 1. Lens Cap Notch