Key Fob Assignment
The key fob on security system motorcycles must be set so it will operate the alarm system on the vehicle. This assignment must be completed with no pauses greater than 10 seconds between steps. Turn the ignition OFF after both key fobs have been assigned. The programming mode will also exit after 60 seconds has elapsed without detecting any key fob sign up messages or turn signal activity.
Procedure
To assign a key fob to a motorcycle, refer to Table 1.
Two key fobs may be assigned to the security system. The first successful attempt to program a key fob will disable all previously assigned key fobs. If a second key fob is to be programmed, it must be done in the same programming sequence as the initial key fob.
Table 1. Key Fob Assignment
STEP
NO.
ACTION
WAIT FOR CONFIRMATION
NOTES
1
Turn IGN key ON-OFF-ON-OFF-ON
2
Press left turn switch 2 times and release
1,2,3, or 4 flashes turn signals & indicators depending on vehicle configuration
(See BATTERY DISCONNECTS AND CONFIGURING section)
1 flash - Worldwide TSM, no security system
2 flashes - North American/Domestic configuration TSSM
3 flashes - Netherlands configuration TSSM
4 flashes - international configuration TSSM
3
Press right turn switch 1 time and release
1 flash turn signals & indicators
4
Press left turn switch 1 time and release
2 flashes turn signals & indicators
5
Press and hold key fob button until confirmation is received
2 flashes turn signals & indicators
This may take 10-25 seconds
6
If you have two key fobs, press and hold button on second key fob until confirmation is received
2 flashes turn signals & indicators
Optional step
7
Turn IGN key OFF