WARNING
Shift transmission to neutral before starting engine to prevent accidental movement, which could result in death or serious injury. (00044a)
NOTICE
The engine should be allowed to run slowly for 15-30 seconds. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Failure to comply can result in engine damage. (00563b)
NOTE
Do not open the throttle before starting the engine.
  1. Bring an assigned fob within range.
  2. See Figure 1. Switch the OFF/RUN switch to the RUN (3) position.
    3. NOTE
    • When ignition is ON the check engine light will light and stay on until engine is started. Service would be required when the engine is started and the check engine light stays on.
    • The fuel pump may run for a few seconds to prime the fuel system prior to starting.
    • As the switch is placed in the RUN position a click noise will be heard as the automatic compression release (ACR) valve opens allowing for easier starting. If the engine is not started within approximately 10 seconds a second click will be heard as the ACR valve closes.
  3. Though the illuminated green neutral lamp indicates that the transmission is in neutral, verify neutral by rolling the motorcycle back and forth with the clutch lever out.
  4. Squeeze the clutch lever against the handlebar.
  5. Press the start switch (5).
  6. When the engine has started, you can operate your motorcycle as you normally would after raising the jiffy stand.
1Hazard
2Off
3Run
4Right turn signal
5Start
6Traction control (if equipped)
Figure 1. Right Hand Control Switches