WARNINGThe automatic-on headlamp feature provides increased visibility of the rider to other motorists. Be sure headlamp is on at all times. Poor visibility of rider to other motorists can result in death or serious injury. (00030b)
WARNINGDo not operate vehicle with forks locked. Locking the forks restricts the vehicle's turning ability, which could result in death or serious injury. (00035a)
A Motorcycle with a keyless ignition does not require a key for operation. Instead, an assigned security fob must be present or the PIN must be used before the motorcycle can be started.
The key supplied with the motorcycle is for the fork lock. See Operation → Controls, Instruments and Switches.
Ignition Mode
With security fob present, set the OFF/RUN switch to RUN. The lights and instruments become operational and the motor can be started. To disarm the security system using the PIN, see SECURITY SYSTEM → Arming and Disarming.
The motorcycle remains on (or the engine continues running) until the OFF/RUN switch is set to OFF. Taking the security fob out of range will not shut down the engine or turn off the motorcycle after it is turned on. However, the speedometer will display a NO FOB message if the motorcycle begins moving without the fob present.
NOTE
With the OFF/RUN switch in RUN, the system will turn off after 15 minutes of inactivity.
When parked, set the OFF/RUN switch to OFF and take the security fob from the motorcycle to prevent theft or startup. With the motorcycle turned off and the security fob out of range, the starter, ignition system and OFF/RUN switch remain disabled, immobilizing the motorcycle.
Accessory Mode
See Operation → Left Hand Control Switches → Left Hand Switch Module
. With the security fob present, press and hold the TRIP switch (1). The instruments and accessory circuit are powered. The headlamp (high and low beam) and turn signal lamps remain off. While in accessory mode:
- The speedometer displays the odometer functions.
- Power is supplied to the USB port.
- The headlamp halo will illuminate.
- The headlamp can be activated by pressing the headlamp flash to pass switch.
- The stop lamps can be operated.
To turn off accessory mode, press and hold the TRIP switch.
Do not leave the motorcycle in accessory mode for an extended period. This can discharge the battery. If the vehicle is left in accessory mode for two hours, the vehicle will automatically shut off to prevent complete battery discharge. To resume accessory mode, press and hold the TRIP switch.