Removal
NOTICE
Polycarbonate windshields/wind deflectors require proper attention and care to maintain. Failure to maintain polycarbonate properly can result in damage to the windshield/wind deflector. (00483e)
NOTICE
Use only Harley-Davidson recommended products on Harley-Davidson windshields. Do not use harsh chemicals or rain sheeting products, which can cause windshield surface damage, such as dulling or hazing. (00231c)
NOTE
Windshields require special care. Do not use ammonia-based or gas station window cleaners. These cleaners can damage the windshield. For proper windshield maintenance, see After Riding → Windshield Care.
| 1. | See Figure 1. Remove fairing. a. Point the front wheel straight forward. b. Open clamps (4). c. Straddle fender. Lift fairing (3) up over headlamp. |
Installation
WARNINGBe sure that steering is smooth and free without interference. Interference with steering could result in loss of vehicle control and death or serious injury. (00371a)
| 1. | See Figure 2. Inspect fairing. a. Verify inner fairing bumpers (1) and clamp bumpers (3) are in place, clean, and in good condition. b. Open and close clamps (4) to verify they are in working order. NOTE If damage or wear is noticed, see a Harley-Davidson dealer. | |
| 2. | Install fairing. a. Point the front wheel straight forward. b. Open clamps (4). c. Straddle front fender. Place fairing over headlamp and onto front forks (5). d. See Figure 1. Position upper bumper (2) on upper fork bracket (1). e. Verify lower bumper (5) is seated on lower fork bracket (6). f. Lock clamps. g. Verify the upper bumpers and lower bumpers are properly seated and fairing is secure. h. Verify there are no cables or wires pinched. |
| 1 | Upper fork bracket |
| 2 | Upper bumper |
| 3 | Fairing |
| 4 | Clamp |
| 5 | Lower bumper |
| 6 | Lower fork bracket |
Figure 1. Fairing Installed
| 1 | Inner fairing bumper (8) |
| 2 | Inner fairing |
| 3 | Clamp bumper (2) |
| 4 | Clamp (2) |
| 5 | Front fork (2) |
Figure 2. Fairing Clamps