NOTE
IFCU backlighting is a dimming function that activates after a slight delay.
This dimming function can be set to automatic (switches based on ambient light) and will briefly change when ambient lighting changes (such as going through a tunnel). This function can also be set to manual and the user controls the brightness of the screen.
Speedometer
WARNING
Travel at speeds appropriate for road and conditions and never travel faster than posted speed limit. Excessive speed can cause loss of vehicle control, which could result in death or serious injury. (00008a)
See
Figure 1. The speedometer (4) registers forward vehicle speed in miles per hour (mph) (U.S.) and/or kilometers per hour (km/h).
Tachometer
NOTICE
See OPERATING RECOMMENDATIONS section. Do not operate the engine above maximum safe RPM as shown under OPERATION (red zone on tachometer). Lower the RPM by upshifting to a higher gear or reducing the amount of throttle. Failure to lower RPM may cause equipment damage. (00159a)
See
Figure 1. The tachometer (2) measures the engine speed in revolutions per minute (rpm x 1000).
Fuel Gauge
See
Figure 1. The fuel gauge (5) indicates the approximate amount of fuel in the fuel tank.
Voltmeter
See
Figure 1. The voltmeter (1) indicates the measured electrical system voltage. With the engine running above 1500 rpm, the voltmeter registers 13.0-14.5 V with battery at full charge.
Odometer
See
Figure 1. The odometer (3) indicates the total accumulated mileage for the motorcycle. Press the trip switch to cycle through the different widget displays.
Figure 1. IFCU Instruments
Figure 2. IFCU Indicators
Figure 3. IFCU Indicators