See Figure 1 and Figure 2. Some models have up to two power ports. One port is on the right side of the fairing. The other port is in the Tour-Pak.

These ports can be used to power or charge 12 VDC accessories with a standard automotive power connector. Follow the manufacturer instructions when installing and operating accessories. Firmly push the accessory connector into the power port.

WARNING

Be sure that steering is smooth and free without interference. Interference with steering could result in loss of vehicle control and death or serious injury. (00371a)

NOTE

Before riding, rotate handlebars to the full right position. Check for contact between installed accessories or wiring and the fuel tank.
Do not use the power port as a cigarette lighter. Damage to the socket may occur. See an authorized Harley-Davidson dealer for available accessories.

The port is energized while the motorcycle is turned on or in accessory mode. Powering accessories for an extended time while the engine is not running will drain the battery.

The maximum current draw for all connected accessories is 15 amps. This includes the total current for all power ports and any other accessories installed on the motorcycle. If excessive current is detected, the system cuts off power to the port. The system automatically enables power to the port again when it senses the overcurrent situation has ceased (such as when a faulty or high powered accessory has been removed).

Items charging in the power port may cause interference with radio reception.

Figure 1. Fairing Power Port

Figure 2. Tour-Pak Power Port