Fascia Lamps
All fascia lamps are LED assemblies with no replaceable bulbs. See service manual or Harley-Davidson dealer to replace entire assembly.
US models: The fascia lamps serve as tail lamps and rear turn signals.
Tail Lamp Bulb: Canadian and HDI Models
| 1. | Remove two screws to release tail lamp assembly from chrome base. | |
| 2. | See Figure 1. Disconnect tail lamp connector (3). | |
| 3. | Rotate bulb socket (4) 1/4 turn counterclockwise and remove from tail lamp assembly. Pull bulb from socket. | |
| 4. | Coat base of new bulb with ELECTRICAL CONTACT LUBRICANT. Install new bulb in socket. | |
| 5. | Insert socket (4) into tail lamp assembly and rotate 1/4 turn clockwise. | |
| 6. | Connect tail lamp connector (3). | |
| 7. | Place tail lamp into position against chrome base. NOTE Over-tightening screws can crack the lens. | |
| 8. | Install two screws. Tighten to 2.3–2.7 N·m (20–24 in-lbs). | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 9. | Test tail lamp operation. |
| 1 | Lens |
| 2 | Base |
| 3 | 4-pin multilock connector |
| 4 | Bulb socket |
Figure 1. Tail Lamp Assembly