NOTICE
Never attempt to tamper with or alter the vehicle odometer. This is illegal. Tampering with or altering a vehicle odometer may cause equipment damage. (00160a)
NOTE
The trigger switch is located on the front of the left hand control. See Operation → Left Hand Control Switches → Left Hand Switch Module (typical).
Odometer
See Figure 1. The odometer shows the total accumulated mileage for the motorcycle. Press the trigger switch to cycle through different odometer functions. The time (Freewheeler® (FLRT)) and odometer can be displayed while the motorcycle is turned off by pressing the trigger switch.
Changing units (Freewheeler (FLRT)): With odometer displayed, press and hold the trigger switch until the units change to MI or KM for motorcycles without an audio system. All odometer functions will display the selected units.
Changing units (Tri Glide Ultra (FLHTCUTG)): Change the settings in the radio to ENGLISH UNITS or METRIC. All radio and odometer functions will display the selected units. See BOOM! BOX OWNER'S MANUAL.
Trip Odometers
The two trip odometers (A and B) display the total accumulated mileage since they were last reset. To check, press and release the trigger switch until the desired trip odometer (A or B) is displayed.
Reset: With the desired trip odometer displayed (A or B), press and hold the trigger switch until the selected trip odometer resets to zero.
Fuel Range
The fuel range display shows the approximate mileage available with the amount of fuel left in the fuel tank. The range display is only updated when the vehicle is moving.
Display Fuel Range: With the ignition switch in the ACCESSORY or IGNITION position, press the trigger switch until fuel range is displayed. The fuel range is indicated by the letter "R" in the left side of the display. The calculated remaining distance (miles or kilometers) to empty is displayed, based on the amount of fuel in the tank.
Low Fuel: The fuel range is automatically displayed in the odometer window when the low fuel lamp is on. When the fuel range drops to 10 miles or 10 kilometers remaining, the odometer window displays "LO RNG" to indicate that the motorcycle is nearly out of fuel. Refuel as soon as possible. Refer to Specifications → Specifications → Capacities.
Turn Off Automatic Low Fuel Popup: With the fuel range displayed, hold the trigger switch until the fuel range flashes two times. To turn this feature back on, hold the trigger switch until the fuel range flashes once.
Reset: Resetting the low fuel warning lamp and fuel range requires sufficient fuel in the tank and an ignition cycle change (IGNITION-OFF-IGNITION).
Adding at least 7.6 L (2 USgal) of fuel allows the fuel range to update. The fuel range slowly updates over the next 48 km (30 mi) after refueling.
Battery Reconnection and Initialization: If the battery is disconnected and reconnected, the gauge requires approximately a half tank of fuel to initialize fuel range functionality.
Digital Tachometer: Freewheeler (FLRT)
Press and release the trigger switch until the digital tachometer is displayed. The odometer window briefly displays a "GEAR/RPM" message, then displays the current gear and engine speed (revolutions per minute).
Time: Freewheeler (FLRT)
See Figure 2. On Freewheeler® (FLRT) models, the time is displayed in the odometer window. Perform the following steps to configure time.
  1. Turn the ignition switch to ACCESSORY or IGNITION.
  2. Repeatedly press the trigger switch until the time is displayed.
  3. 12HR/24HR: Press and hold the trigger switch until 12HR begins to flash. Press the trigger switch to toggle between 12 hour (12HR) or 24 hour (24HR) clock display.
  4. Hour: Press and hold the trigger switch until the hour is flashing. Repeatedly press the trigger switch to advance hours to the correct time.
  5. Minutes: Press and hold the trigger switch until the minutes begin flashing. Repeatedly press the trigger switch to advance minutes to the correct time.
  6. AM/PM: If 12HR was selected, press and hold the trigger switch until AM/PM begins flashing. Press the trigger switch to toggle between AM or PM.
  7. NOTE
    AM or PM will not appear in the regular time display. The motorcycle uses the selection for diagnostic purposes.
  8. Press and hold the trigger switch to save time settings.
  9. Turn ignition switch OFF.
Tip Indicator
WARNING
If tip occurs, check all controls for proper operation. Restricted control movement can adversely affect the performance of the brakes, clutch or ability to shift, which could result in loss of vehicle control and death or serious injury. (00350a)
See Figure 3. If the motorcycle is tipped over, the word "tiP" appears in the odometer window. The engine will not start until the tip condition is reset. See Operation → Starting after Tipover to reset.
No Fob Message
If the motorcycle has a security system and is driven off leaving the fob behind, 'NO FOB' temporarily displays in the odometer window.
Without the fob, the motorcycle can only be started with a manual PIN entry to disarm the security system. See SECURITY SYSTEM → Arming and Disarming.
1Odometer
2Trip odometers (A, B, reset)
3Fuel range (low fuel range)
4Digital tachometer (Freewheeler® (FLRT))
5Trigger switch (left hand control)
Figure 1. Odometer Functions
112-hour/24-hour setting
2Hours setting
3Minutes setting
4AM/PM setting (12-hour mode)
Figure 2. Setting Time: Freewheeler (FLRT)
Figure 3. Tip Indicator