Removal: Without Tour-Pak
  1. Remove screw securing rear of seat.
  2. To protect body assembly finish, cover rear seat mounting bracket with palm of hand.
  3. See Figure 1. While pushing seat forward, raise rear of seat until bracket clears top of body assembly. Push seat rearward slightly to free seat from tongue on rear fuel tank bracket.
Installation: Without Tour-Pak
1. See Figure 2. Firmly push front of seat downward and forward until slot engages tongue.
2. Secure rear of seat with screw. Tighten.
Torque: 5.4–8.1 N·m (48–72 in-lbs) Seat mounting screw
3. Pull up on the front and rear of seat to verify that it is properly secured.
Removal: With Tour-Pak
  1. See Operation → TOUR-PAK. Open Tour-Pak to move passenger seat backrest out of the way.
  2. Remove screw securing rear of seat.
  3. To protect Tour-Pak finish, cover rear seat mounting bracket with palm of hand.
  4. See Figure 1. While pushing seat forward, raise rear of seat until bracket clears top of Tour-Pak. Push seat rearward slightly to free seat from tongue on rear fuel tank bracket.
Installation: With Tour-Pak
  1. See Figure 2. Place seat on frame backbone.
  2. To protect finish of Tour-Pak, cover rear seat mounting bracket with palm of hand.
  3. While raising rear of seat approximately 76.2 mm (3 in), use other hand to firmly push front of seat downward and forward until tongue engages slot in seat.
  4. Push seat rearward until seat retention nut is centered in hole of mounting bracket.
  5. Install seat mounting screw. Tighten to 5.4–8.1 N·m (48–72 in-lbs).
  6. Pull up on the front and rear of seat to verify that it is properly secured.
Figure 1. Seat Tongue
Figure 2. Seat Mounting Slot