Removal

WARNING

To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)

NOTICE

When replacement is required, use only the specified sealed beam unit or bulb, available from a Harley-Davidson dealer. An improper wattage sealed beam or bulb, can cause charging system problems. (00209a)

1.	Remove main fuse. See Service Procedures → Fuses.
2.	See Figure 2. Loosen the trim ring screw (4). Remove the trim ring.
3.	Support the lens and reflector.
4.	See Figure 1. While compressing the release tabs (1) on the connector, pull the connector off the bulb spade terminals.
5.	Pull the rubber boot (2) back.
6.	Press the loop (3) on the wire retaining clip (4) down and to one side to disengage the free end of the clip from the metal catch. Rotate the clip up. Remove the bulb from the lens and reflector.

1	Release tab
2	Rubber boot
3	Loop
4	Retaining clip

Figure 1. Headlamp

Installation

WARNING

Handle bulb carefully and wear eye protection. Bulb contains gas under pressure, which, if not handled carefully, could cause serious eye injury. (00062b)

NOTICE

Never touch the quartz bulb. Fingerprints will etch the glass and decrease bulb life. Handle the bulb with paper or a clean, dry cloth. Failure to do so could result in bulb damage. (00210b)

1.	Align bulb tabs with slots in the reflector. Install the bulb.
2.	See Figure 1. Rotate the retaining clip down against the bulb flange. Press the wire loop down and in until the free end of the clip engages the metal catch.
3.	See Figure 2. Match the rubber boot TOP arrow to the reflector arrow (1). Fit the rubber boot over the spade terminals of the bulb. Press the air out of the boot to seal over the lens and the reflector assembly.
4.	Install the connector.
5.	Verify that the adapter ring (2) is in place with the two tabs of the ring in the two bulges in the headlamp shell.
6.	Match the single tab on the reflector to the notch (3) on the inside of the adapter ring.
7.	Fit the trim ring and rotate the ring clockwise to lock the ring on the lens and reflector.
8.	Install screw (4) and nut.
9.	Tighten screw. Torque: 1.0–1.6 N·m (9–14 in-lbs)
10.	Install main fuse. See Service Procedures → Fuses.
	WARNING Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)
11.	Test headlamp operation.
12.	Align headlamp. See Service Procedures → Headlamp Alignment.

1	Arrows
2	Adapter ring
3	Notch
4	Screw

Figure 2. Headlamp Assembly