NOTE

Some indicator lamps may not be on all models.

Check Engine Lamp

See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. The check engine lamp indicates the condition of the engine/engine management system.

The check engine lamp normally comes on when the ignition is first turned on. During this time, the engine management system runs a series of self-diagnostics.

If the engine lamp does not turn off after starting the engine or comes on at any other time, see a Harley-Davidson dealer.

Low Fuel Lamp

Solid: See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. The low fuel warning lamp indicates when the gasoline in the tank reaches the low fuel level (approximate). Refer to Specifications → Specifications → Capacities for the low fuel level. See Controls and Indicators → Odometer Functions for fuel range features.

Flashing: If the low fuel lamp flashes continuously or remains on after filling the fuel tank, see a Harley-Davidson dealer.

Battery Discharge Lamp

See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. The battery discharge lamp indicates overcharging or undercharging of the battery. See Maintenance and Lubrication → Battery Maintenance.

Security Lamp

See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. The security lamp displays the status of the security system and electrical self-diagnostics for the motorcycle. See SECURITY SYSTEM → Security System for security system operation.

Flashing: The security system is armed.

Solid (security system armed): The alarm has been activated.

Solid (security system disarmed): If the lamp remains on, see a Harley-Davidson dealer.

Turn Signal Indicator

Flashing: See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. A turn signal is activated. When the 4-way hazard flashers are operating, both turn indicators flash simultaneously.

Rapid flashing: A turn signal bulb is not operating. Exercise caution and use hand signals. Replace inoperative components at earliest opportunity.

Headlamp High Beam Lamp

See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. The headlamp high beam indicator lamp is lit when the high beam switch is activated.

The headlamp high beam indicator lamp flashes when stealth mode is enabled and activated.

Neutral Lamp

See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. The neutral lamp is on when the transmission is in neutral.

Cruise Control Lamp

Off: See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. Cruise control is not enabled.

Orange: Cruise control is enabled. Cruising speed is not set or has been disengaged.

Green: Cruising speed is set. Motorcycle speed is maintained by cruise control.

Gear Indicator

FLHTP: See Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. On equipped models, the currently selected gear (1-6) is displayed in the odometer window. The gear indicator is calculated from the vehicle speed and engine speed. The gear indicator remains blank when the transmission is in neutral, the clutch lever is pulled in or the vehicle is not moving.

The gear indicator may be momentarily inaccurate depending on rider clutch use characteristics and clutch wear. This can occur if the clutch is allowed to slip either due to excessive wear, misadjusted clutch or if the operator rides the clutch.

ABS Lamp

WARNING

If ABS lamp continues flashing at speeds greater than 5 km/h (3 mph) or remains on continuously, the ABS is not operating. The standard brake system is operational, but wheel lock up can occur. Contact a Harley-Davidson Dealer to have ABS repaired. A locked wheel will skid and can cause loss of vehicle control, which could result in death or serious injury. (00361b)

Flashing: See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. On vehicles with ABS, the ABS lamp begins flashing when the vehicle is turned on. The flashing lamp indicates that the system is in self-diagnosis mode. It continues to flash until motorcycle speed exceeds 5 km/h (3 mph). ABS is not operational until the lamp turns off.

Solid: Continuous illumination of the lamp indicates an ABS malfunction. The ABS is disabled and the brakes are operating as if they were non-ABS brakes. See a Harley-Davidson dealer for service.

Oil Pressure Lamp

NOTICE

If the oil pressure indicator lamp remains lit, always check the oil supply first. If the oil supply is normal and the lamp is still lit, stop the engine at once and do not ride further until the trouble is located and the necessary repairs are made. Failure to do so may result in engine damage. (00157a)

See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. The oil pressure lamp turns on when the ignition is turned on. The lamp remains on until the engine is started.

If the lamp is on while the engine is running, sufficient oil is not circulating through the engine.

Check and add engine oil as necessary. See Maintenance and Lubrication → Check Engine Oil Level. For other possible causes, see Troubleshooting → Engine.

If the engine oil level is sufficient and the lamp remains on, stop the engine immediately and see a Harley-Davidson dealer for service.

Emergency Lamps Indicator

See Controls and Indicators → Instruments → Instruments and Indicators: FLHP and Controls and Indicators → Instruments → Instruments and Indicators: FLHTP. The emergency lamps indicator illuminates to indicate that the emergency lamps circuit is on.

Green: Front emergency lamps are activated.

Orange: Rear emergency lamps are activated.

Alternating Green/Orange: Both front and rear emergency lamps are activated.