Removal
NOTE
The seat screw may be difficult to access if the Tour-Pak is in the forward position. If necessary, see Controls and Indicators → TOUR-PAK to temporarily move the Tour-Pak.
1. Open Tour-Pak lid.
2. Open one of the saddlebag lids.
3. See Figure 1. Remove screw to release seat strap from bracket.
NOTICE
Detach passenger seat strap before removing seat. Failure to do so can result in damage to rear fender paint. (00225a)
4. FLHRC: See Figure 4. Pull strap through slots in seat to remove.
5. Remove screw to release seat from top of rear fender.
NOTE
Cover the seat mount mounting bracket with palm of hand to prevent damage to Tour-Pak.
6. See Figure 2 and Figure 3. Raise rear of seat. Pull seat rearward to disengage the tongue from the slot in the seat.
Installation
NOTE
Cover the seat mount mounting bracket with palm of hand to prevent damage to Tour-Pak.
1. See Figure 2 and Figure 3. Align seat slot with tongue behind the fuel tank. Push seat forward to engage seat.
2. See Figure 1. Secure seat bracket to rear fender with screw. Tighten screw to 5.4–8.1 N·m (48–72 in-lbs).
3. Pull up on seat to check that it is properly secured.
4. FLHRC: See Figure 4. Install strap through slots in seat.
5. See Figure 1. Insert strap in slot on seat strap bracket.
6. Install screw and washer. Tighten to 5.4–8.1 N·m (48–72 in-lbs).
7. Close the saddlebag lid.
8. Close Tour-Pak lid.
NOTE
Install Tour-Pak back in desired position if removed. See Controls and Indicators → TOUR-PAK.
1Seat strap screw
2Seat strap
3Seat screw
Figure 1. Seat Strap Screw
Figure 2. Seat Tongue
Figure 3. Seat Mounting Slot
Figure 4. Strap Slots: FLHRC