Removal
WARNING
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)
  1. See Figure 1. Remove the thumbscrew (1).
  2. Remove the passenger pillion (2).
  3. Remove mounting nuts (4).
  4. Raise the rear of the seat (5, 6, 7, or 8) off the mounting posts and slide seat tongue out of the frame.
  5. Remove grab strap (3).
Installation
  1. See Figure 1. Install seat strap (3) on the mounting posts on rear fender.
  2. Insert tongue at front of seat into the channel in the frame.
  3. Install rear of seat on the mounting posts on rear fender. Install mounting nuts (4) and tighten.
  4. Slide slots on passenger pillion (2) to engage the seat mounting nuts.
  5. Install thumbscrew (1) and tighten.
1Thumbscrew
2Pillion
3Grab strap
4Seat mounting nut (2)
5Seat: FLSTN
6Seat: FLSTF, FLSTFB, FLSTFBS
7Seat: FXSB
8Seat: FLSTC
Figure 1. Seat: FLSTC, FLSTF, FLSTFB, FLSTFBS, FLSTN, FXSB
Figure 2. Seat Mounting Stud: FLSTN