See Figure 1. The fuel gauge (1) uses a sweep indicator on a scale from F (full) to E (empty). The red end of the scale indicates a low fuel level in the tank.

See Figure 1 or Figure 2. The speedometer (2) registers miles per hour (U.S. models only), kilometers per hour (international models only) or is dimensioned in both mph and km/h for required markets.

Instrument backlighting activates after a slight delay. Changes to ambient lighting, such as going through a tunnel, may briefly change backlighting.

Pressing the trip switch with the ignition switch in any position activates the odometer reading.

The odometer window (3) in the speedometer face also provides the following selectable displays:

Press and release the trip switch to cycle through the displays.

See Figure 3. To check mileage or to reset trip odometers, the ignition switch must be in the ACC or IGN position. Press and release the trip switch (1) until the desired trip odometer register, A (2) or B (3) is displayed. An A or B in the upper left of the display window identifies the trip odometer.

To reset or zero trip odometers, have desired (A or B) odometer in display window. Press the trip switch and hold for approximately three seconds. The trip odometer resets to zero.

See Figure 3. Press and release the trip switch to cycle through the odometer displays to select the gear number and the tachometer display. The odometer shows the current gear (1-6) and the engine speed in revolutions per minute (rpm).

When the transmission is in neutral or the clutch lever is pulled in, the gear number is blank.