Removal
- Remove two screws to release tail lamp assembly from chrome base.
- See Figure 1. Disconnect tail lamp connector (3).
- Rotate bulb socket (4) a quarter turn counterclockwise and remove from tail lamp assembly. Remove bulb.
Installation
| 1. | Coat base of new bulb with ELECTRICAL CONTACT LUBRICANT. Install new bulb. | |
| 2. | See Figure 1. Insert socket (4) into tail lamp assembly. Rotate a quarter turn clockwise. | |
| 3. | Attach tail lamp connector (3). | |
| 4. | Place tail lamp into position against chrome base. NOTE Do not over-tighten screws. | |
| 5. | Install two screws. Tighten to 2.3–2.7 N·m (20–24 in-lbs). | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 6. | Check operation of all lamps. |
| 1 | Bulb socket |
| 2 | Tail lamp connector |
| 3 | Base |
| 4 | Lens |
Figure 1. Incandescent Tail Lamp Assembly