Hazard Warning 4-Way Flasher

See Figure 1. The hazard switch (1) is used to leave a stranded motorcycle in the 4-way flashing mode. With the flashers, the motorcycle can be left with the ignition off until assistance is found.

With the OFF/RUN switch in the run position, press on the hazard warning triangle to activate the 4-way flashers.

NOTE

The fob must be present when turning on the 4-way flashers and when canceling the flashers.
The four-way flashers will operate when the vehicle is tipped over regardless of OFF/RUN switch position. See Operation → Starting after Tipover.

Turn OFF/RUN switch to the off position. The 4-way flashers continue for 2 hours or until cancelled by the rider.
To cancel, turn the OFF/RUN switch to the run position. Press the warning triangle above the start switch.

Mode

See Figure 1. Press the mode button (2) to change the ride mode.

OFF

See Figure 1. Position the engine OFF/RUN switch to the Off position (3) to shut off the engine.

RUN

See Figure 1. Push the engine OFF/RUN switch to run (5) to enable engine start and run. The engine OFF/RUN switch must be in the run position to start or operate the engine.

Start

See Figure 1. Position the engine OFF/RUN switch to the Run position (5) to allow the engine to start.

Switch the OFF/RUN switch to the run position (5). Shift the transmission to neutral. The neutral (green) indicator illuminates. See Operation → Starting the Engine.
Press the start switch (4) to operate the starter motor.

NOTE

When the starter is activated, the headlamp is momentarily turned off to reduce battery load.
If the engine does not start, the starter motor runs for 10 seconds and stops with a single press. Press the start switch to try again. After several unsuccessful attempts to start the engine, see a Harley-Davidson dealer.

See Figure 2. Press the previous button (1) to select the previous media file.

See Figure 2. Press the next button (4) to select the next media file.

Play/pause

See Figure 2. Press the play/pause button (2) to play or pause the current media file.

Volume up

See Figure 2. Press the volume up button (3) up to increase volume.

Volume down

See Figure 2. Press the volume up button (5) up to decrease volume.

Voice recognition

See Figure 2. The voice recognition switch (6) activates the voice recognition features on a connected mobile device.

Traction control

See Figure 2. The traction control button (7) activates and deactivates the traction control system.

Disable: Press button for 1 second with engine running and vehicle stopped.
Enable: Press button at anytime to resume traction control operation.

1	Hazard
2	Mode
3	Off
4	Start
5	Run

Figure 1. RHCM - Top

1	Previous
2	Play/pause
3	Volume up
4	Next
5	Volume down
6	Voice recognition
7	Traction control

Figure 2. RHCM - Bottom

Table 1. Right Hand Control Switches/Buttons

SWITCH/ BUTTON	NAME	FUNCTION
	Hazard	Press to activate the 4-way flashers.
MODE	Mode	Press to change the ride mode.
	Off	Position to stop the engine or to prevent the engine from starting.
	Start	Press to start the engine.
	Run	Position to allow the engine to start.
	Previous	Press to select the previous media file.
	Play/pause	Press to play or pause the current media file.
	Volume up	Press to increase volume.
	Next	Press to select the next media file.
	Volume down	Press to decrease volume.
	Voice recognition	Initiates a voice recognition session.
	Traction control	Press to deactivate and activate traction control.