Align headlamp. See Service Procedures → Headlamp.
Check Bank Angle Lamp Alignment (If equipped)
NOTE
- Vehicle must be in motion to enable full operation of bank angle lighting.
- During the aiming procedure, only the two outer segments of the bank angle lamp illuminate.
Place vehicle in accessory mode. See Accessory Mode inOperation → Keyless Ignition.
Access settings menu, see Operation → Instruments.
To check bank angle lighting, navigate to aiming ready menu. SETTINGS> RIDE CUSTOMIZATION> BANK LAMP AIMING> AIMING READY.
See Figure 1. If bank angle lights do not align as shown, adjustment is necessary.
| 1 | Low beam pattern |
| 2 | Left bank angle light |
| 3 | Right bank angle light |
| 4 | Horizontal centerline |
| 5 | Horizontal line 6.65 cm (2.6 in) lower than centerline |
Figure 1. Bank Angle Light Pattern
Adjustment
| 1. | See Figure 2. Loosen bank angle light screws. | |
| 2. | See Figure 1. Set vertical adjustment. | |
| 3. | See Figure 2. Tighten screws. Torque: 8–10 N·m (71–89 in-lbs) Bank angle light screws |
Figure 2. Bank Angle Light Screw (right side shown)