The motorcycle comes from the factory with two key fobs. The key fobs have been electronically assigned by your dealer to disarm the security system for your motorcycle. Only two fobs can be assigned to a motorcycle at any one time. Replacement key fobs can be purchased and assigned for your motorcycle by a Harley-Davidson dealer.
A unique number is attached to a tag on the key fobs. Write your key fob number in the space provided in the front of this manual.
Retractable Key
The retractable key can be used to manually lock and unlock the fork lock and saddlebags.
Extend key: See Figure 1. Press the button (2) to extend the key.
Retract key: Press the button to release the key. Rotate the key back into the fob body.
Security System
The security system can be disarmed when an assigned key fob is within range. Always carry the fob when riding, loading, fueling, moving, parking or servicing the motorcycle. The range for disarming the security system is approximately 1.5 m (5 ft) from the center of the motorcycle.
See Operation → Keyless Ignition to operate the motorcycle. See SECURITY SYSTEM for a complete description of security system features.
Riding away without the fob: The Infotainment Control Unit (IFCU) temporarily shows NO FOB if the motorcycle is ridden away without the key fob. To restart a motorcycle without a key fob, disarm the security system with the PIN. See SECURITY SYSTEM → Arming and Disarming.
Removing key fob when parked: Always lock the fork and remove the key fob when parked. Do not leave the key fob attached to the handlebars or stored in a luggage compartment. If the key fob is within range, the motorcycle can be started and the alarm will not activate.
Replacing the Battery
WARNING
CONTAINS BUTTON OR COIN CELL BATTERY. KEEP OUT OF REACH OF CHILDREN.
Ingestion can result in death or serious injury. Choking, chemical burns and perforation of soft tissue may result. Severe burns can occur within 2 hours of ingestion or placement in any part of the body. Seek medical attention immediately. (13105b)
It is recommended to replace the fob battery every year.
| 1. | See Figure 1. Press button (2) to extend key (1). | |
| 2. | Turn fob over. Remove any keys or key rings attached to the loop on the fob case. | |
| 3. | Separate key fob NOTE Do not twist screwdriver. a. See Figure 2. Insert blade of a 3/16-inch flathead screwdriver in the thumbnail slot (1) b. Push in and up until open. | |
| 4. | Remove the battery and discard. a. Carefully insert the blade of a 1/8-inch flathead screwdriver under the battery (3) and lift. b. Remove the battery from the battery tray. | |
| 5. | Install a new battery (CR2032) with the positive side up. | |
| 6. | Snap the cover and fob body together. a. Align the positioning tabs (2) with the positioning slots (4). b. Snap the fob halves together. c. Make sure the fob cover is seated all the way around the fob body. | |
| 7. | Test the fob by pressing the unlock button then the lock button and verify the saddlebag locks operate. |
| 1 | Key |
| 2 | Button |
| 3 | Fob |
Figure 1. Key Operation
| 1 | Thumbnail slot |
| 2 | Positioning tab (2) |
| 3 | Battery |
| 4 | Positioning slot (2) |
Figure 2. Fob Battery