NOTICE

There are no serviceable parts inside the unit; leave all servicing to qualified service personnel. Disassembly of the unit could result in equipment damage and/or equipment malfunction. (00172a)

Updating Software

1.	Check software version. a. Refer to Operation → Infotainment. Navigate to Settings> Software> Software Information. This menu will show the current software version on the Instrument Module (IM). b. Check for latest software version. See website: www.h-d.com/infotainment-support.
2.	Update software. a. Download the latest software version to Universal Serial Bus Type-C (USB-C) device. See website: www.h-d.com/infotainment-support. b. Unzip the downloaded file to extract the gpg file. The gpg file must be at the root directory of your USB-C drive in order for it to be detected by the IM. Only one gpg file should be present at the root directory level. c. Refer to Operation → USB Port → USB-C Port. Connect USB-C drive to motorcycle. d. Navigate to Settings> Software> Infotainment SW Update. e. Verify correct update is available. f. Load update. g. Allow update to complete. h. Remove USB-C drive.
3.	Return to Software Information to verify correct version has been loaded.

Fuel Gauge

See Figure 1. The fuel gauge indicates the approximate amount of fuel in the fuel tank.

Speedometer

WARNING

Travel at speeds appropriate for road and conditions and never travel faster than posted speed limit. Excessive speed can cause loss of vehicle control, which could result in death or serious injury. (00008a)

See Figure 1. The IM registers Miles Per Hour (mph) (U.S. models default) and Kilometers Per Hour (km/h) (international models default). The IM can be configured to register either mph or km/h through the settings menu.

Tachometer

See Figure 1. The tachometer measures the engine speed in revolutions per minute (rpm x 1000).

Clock

See Figure 1. The clock displays current time in 12/24 hour format. The settings menu is used to set time and select 12 or 24 hour format.

Odometer display

Pressing the trip button with the OFF/RUN switch in either position activates the odometer reading.

See Figure 1. The odometer display provides the following selectable displays:

Odometer
Trip odometer A
Trip odometer B
Range
Temperature

Press and release the trip button to cycle through the displays.

To check trip mileage or to reset trip odometers, the OFF/RUN switch must be in the RUN position. Press and release the trip button until the desired trip odometer is displayed.

To reset or zero trip odometers, have desired (A or B) odometer displayed. Press the trip button and hold for approximately one second. The trip odometer resets to zero.

The fuel range display shows the approximate mileage available with the amount of fuel left in the fuel tank. With OFF/RUN switch in the RUN position, press the trip button until range is displayed.

The temperature display shows ambient temperature. With OFF/RUN switch in the RUN position, press the trip button until temperature is displayed.

1	Clock
2	Tachometer
3	Speedometer
4	Odometer
5	Fuel gauge

Figure 1. Instruments: Dashboard Display