Removing Battery

1.	Remove chin spoiler. See Service Procedures → Chin Spoiler. a. Remove left chin spoiler extension. b. Remove right chin spoiler extension. c. Remove chin spoiler.
2.	Figure 1 Remove battery negative cable (2) from battery (1).
3.	Remove battery positive cable (3) from battery.
4.	Figure 2 Remove starter cable (1) from starter solenoid (2).
5.	Figure 3 Remove voltage regulator bracket screws (2).
6.	Figure 4 Position voltage regulator bracket (2) out of way.
7.	Remove battery (1).

Installing Battery

WARNING

Connect positive (+) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00068a)

NOTICE

Connect the cables to the correct battery terminals. Failure to do so could result in damage to the motorcycle electrical system. (00215a)

1.	Install battery.
2.	Figure 3 Position voltage regulator bracket (1).
3.	Install voltage regulator bracket screws (2). Tighten. Torque: 4–7 N·m (35–62 in-lbs)
4.	Figure 1 Install battery positive cable (3) to battery. Tighten. Torque: 6.8–7.9 N·m (60–70 in-lbs)
5.	Install battery negative cable (2) to battery. Tighten. Torque: 6.8–7.9 N·m (60–70 in-lbs)
6.	Figure 2 Install starter cable (1) to starter solenoid (2). Tighten. Torque: 3–4.6 N·m (27–41 in-lbs) a. Figure 5 Route starter cable (2) in bracket (1).
7.	Install chin spoiler. See Service Procedures → Chin Spoiler. a. Install chin spoiler b. Install right chin spoiler extension. c. Install left chin spoiler extension.

1	Battery
2	Negative cable
3	Positive cable
4	Terminal screw (2)

Figure 1. Battery Cables

1	Starter cable
2	Starter solenoid
3	Starter cable nut

Figure 2. Starter Cable

1	Voltage regulator bracket
2	Screws

Figure 3. Voltage Regulator Bracket Screws

1	Battery
2	Voltage Regulator Bracket

Figure 4. Voltage Regulator Bracket

1	Voltage regulator bracket
2	Starter cable
3	Voltage regulator

Figure 5. Negative Cable Bracket