See Figure 2.Vehicle off: Press the trip switch (5) to display the accumulated mileage in the odometer display in the Instrument Module (IM).

Vehicle in accessory/ignition mode: Press the trip switch to cycle through the widget displays.

If heated hand grips installed: Press trip switch to cycle through the widget displays to get to HG (LOW, MID or HIGH) in the odometer display. Long Press the Trip switch to turn the grips OFF. It does not matter if the grips are in low, medium or high.

High beam: See Figure 1. Push the headlamp switch up to activate the high beam. The (blue) high beam indicator in the IM is lit when the high beam is on. Refer to Table 1.

Low beam: Press the headlamp switch down to activate the low beam.

Flash-to-pass: When the low beam switch is on, press and release the flash to pass switch to flash the high beam before passing another vehicle. The high beam indicator lamp on the IM is illuminated as long as the flash to pass switch is pressed.

When in accessory, press the headlamp (flash-to-pass) switch to activate the headlamp. Refer to Table 1.

See Figure 2. The CRUISE/SET/RESUME switch assembly (2, 3, 4) automatically regulates the speed of the vehicle. Refer to Operation → Cruise Control.

CRUISE: Press the CRUISE OFF/ON button (3) to enable cruise control. The cruise control indicator in the IM lights orange. Pressing the CRUISE OFF/ON button again turns off cruise control, and the cruise control indicator turns off.

SET/-: With cruise control enabled, press SET/- (4) to set the cruising speed. The cruise control indicator in the IM lights green. While at cruising speed, press SET/- to decrease the regulated speed. Tapping SET/- decreases the speed by 1.6 km/h (1 mph). Holding SET/- down gradually decreases cruise speed.

RES/+: If cruise control is disengaged (such as a braking event), press RES/+ (2) to resume the previous cruising speed. While at cruising speed, press RES/+ to increase speed. Tapping RES/+ increases the speed by 1.6 km/h (1 mph). Holding RES/+ down gradually increases cruise speed.

The auxiliary/fog lamps provide additional light to the road and surrounding environment in dark or rainy conditions. The lamps also give the motorcycle more visibility to other motorists. When the lamps are on, the auxiliary/fog lamp indicator is displayed on the instrument cluster.

See Figure 2. Press the auxiliary/fog lamps switch (7) to activate the auxiliary/fog lamps. Refer to Table 1.

Domestic/Canada configurations: The auxiliary/fog lamps are configured to automatically turn off when the high beam headlamp is turned on, except as required by state/province.

Auxiliary/fog lamps can be configured to turn on or off with high beam by the dealer, based on legal requirements for each location.

Activate: See Figure 2. Press the left turn signal (8) switch to activate the left turn signal. Refer to Table 1.

Cancel (manual operation): If activated, press the left turn signal switch to cancel the left turn signal.

Cancel (automatic operation): If activated, the turn signal lamps automatically cancel when a full turn has been detected based on speed, acceleration and turn completion.

The lamps also cancel if the turn signal has been activated for a prolonged period (20 flashes) while the motorcycle speed is greater than 7 mph (11 km/h). If the motorcycle is stopped or moving slower than this speed, the turn signal continues flashing.

See Figure 2. The horn is operated by pressing the horn switch (6). The horn can be activated for up to 10 seconds at a time. If the horn switch is held for a longer period, the horn automatically deactivates. Refer to Table 1.