Traction Control Switch

See Figure 1. The traction control switch activates and deactivates the traction control system on equipped vehicles. Refer to Table 1.

Disable: Press switch for more than 1 s with engine running and vehicle stopped.

Enable: Press switch at anytime to resume traction control operation.

NOTE

Traction control is automatically enabled at each ignition start cycle. The system will be enabled to the last active Traction Control mode.

For more information on traction control, see Operation → Traction Control.

Hazard Warning 4-Way Flasher

See Figure 1. The hazard switch (2) is used to leave a stranded motorcycle in the 4-way flashing mode. With the flashers, the motorcycle can be left with the ignition off until assistance is found. Refer to Table 1.

With the OFF/RUN/START switch in the RUN (3) position, press the hazard warning switch to activate the 4-way flashers.

NOTE

The fob must be present when turning on the 4-way flashers and when canceling the flashers.
The four-way flashers will operate when the vehicle is tipped over regardless of OFF/RUN/START switch position. Refer to Operation → Starting after Tipover.

Turn OFF/RUN/START switch to the OFF (4). The 4-way flashers continue for 2 hours or until cancelled by the rider.
To cancel, turn the OFF/RUN/START switch to RUN. Press the hazard warning switch.

OFF

See Figure 1. Press the engine OFF/RUN/START switch to OFF (4) to shut off the engine. Refer to Table 1.

RUN

See Figure 1. Push the engine OFF/RUN/START switch to RUN (3) to enable engine start and run. The engine OFF/RUN/START switch must be in the run position to start or operate the engine. Refer to Table 1.

Start

See Figure 1. Switch the OFF/RUN/START switch to RUN (3). Shift the transmission to neutral. The neutral (green) indicator illuminates. Refer to Operation → Starting the Engine.
Press the start switch (5) to operate the starter motor.

NOTE

When the starter is activated, the headlamp is momentarily turned off to reduce battery load.
If the engine does not start, the starter motor runs for ten seconds and stops. Press the start switch to try again. After several unsuccessful attempts to start the engine, see a Harley-Davidson dealer.

Right Turn Signal

Activate:

See Figure 1. Press the right turn signal switch (6) to activate the right turn signal. Refer to Table 1.

Cancel (manual operation): If activated, Press the right turn signal switch to cancel the right turn signal.

Cancel (automatic operation): The turn signal lamps automatically cancel when a full turn has been detected based on speed, acceleration and turn completion.

The lamps also cancel if the turn signal has been activated for a prolonged period (20 flashes) while the motorcycle speed is greater than 7 mph (11 km/h). If the motorcycle is stopped or moving slower than this speed, the turn signal continues flashing.

NOTE

Front turn signal lamps also function as running lamps. This feature may not be available in all markets.

Mode

See Figure 1. Press the mode button (7) to change the ride mode. Refer to Operation → Ride Modes.Refer to Table 1.

NOTE

Last active mode is automatically enabled at each ignition start cycle and when enabled.

1	Traction control
2	Hazard warning
3	Run
4	Off
5	Start
6	Right turn signal
7	Mode

Figure 1. Right Hand Control Module (RHCM)

Table 1. Right Hand Control Switches

SWITCH	NAME	FUNCTION
	Hazard	Press to activate the 4-way flashers.
	Traction control	Press the switch to deactivate and activate traction control.
	Off	Press to stop the engine or to prevent the engine from starting.
	Start	Press to start the engine.
	Run	Press to allow the engine to start.
	Right turn	Press to signal a right turn.
	Mode	Press to change the ride mode.