For electrical problems, see a Harley-Davidson dealer who has the necessary parts and equipment to perform electrical services.
NOTE
- Fuses do not reset.
- Only replace a fuse with a fuse of the same rating and type.
Main Fuse
NOTE
The amperage of the main fuse is 50A.
Remove the main fuse whenever you perform maintenance on your motorcycle.
| 1. | Set OFF/RUN/START switch to OFF. | |
| 2. | Remove left side cover. Refer to Service Procedures → Side Covers. | |
| 3. | See Figure 1. Remove cover of main fuse holder (1). | |
| 4. | Remove the main fuse. | |
| 5. | Install the main fuse when maintenance is complete. | |
| 6. | Install main fuse holder cover. | |
| 7. | Install left side cover. |
| 1 | Main fuse holder |
| 2 | Fuse block |
| 3 | Fuse block release |
Figure 1. Fuse Mounts
| 1 | ABS |
| 2 | Infotainment |
| 3 | Battery tender |
| 4 | Powertrain |
| 5 | Open |
| 6 | Open |
Figure 2. Fuses
Replacing Fuses
| 1. | Set OFF/RUN/START switch to OFF. | |
| 2. | Remove left side cover. Refer to Service Procedures → Side Covers. | |
| 3. | See Figure 1 and Figure 2. Remove fuse block from caddy on motorcycle. | |
| 4. | Remove the suspect fuse and inspect the element. Replace the fuse if the element is burned or separated. | |
| 5. | Install fuse block to caddy so the release snaps into place. | |
| 6. | Install left side cover. |