Two Piece Seat

Removal

1.	See Figure 1. Insert key in seat lock (2).
2.	Turn key to release latch (4).
3.	Lift up then back on passenger seat (3) to remove.
4.	Lift up then back on rear of rider seat (1) to remove.

Installation

NOTE

Rider seat may be installed in either high position or low position slots to adjust seat height.

1.	See Figure 2. Insert tabs (3) of rider seat (1) into high position (4) or low position (5) slots in side covers (2).
2.	Lower rear of rider seat (1) into position.
3.	See Figure 1. Engage tabs on passenger seat (3) in slots of seat support.
4.	Lower rear of passenger seat.
5.	Press rear of passenger seat down until a click is heard.
6.	Pull up on the seat to verify it is secure.

Figure 1. Passenger Seat

Figure 2. Rider Seat (Two-piece)

One Piece Seat

Remove

1.	See Figure 3. Insert key in seat lock (5).
2.	Turn key to release latch pin (3) from latch (4).

NOTE

See Figure 3. One-piece seat may be installed in low seat position slots (6) only.

Install

1.	See Figure 3. Insert tabs on front of seat (2) into low seat position slots (6) in side covers (1).
2.	Push seat forward until seat tabs are fully engaged in slots.
3.	Press down on rear of seat until latch pin (3) locks into latch (4).
4.	Pull up on rear of seat to verify it is secure.

Figure 3. Seat, One Piece