Removal
  1. See Operation → TOUR-PAK. Open Tour-Pak to move passenger seat backrest out of the way.
  2. Remove screw securing rear of seat.
  3. To protect Tour-Pak finish, cover rear seat mounting bracket with palm of hand.
  4. While pushing seat forward, raise rear of seat until bracket clears top of Tour-Pak.
  5. See Figure 1. Push seat rearward slightly to free seat from tongue on rear fuel tank bracket.
  6. See Figure 2. Separate the heated seat connector half from the power connector half of the wiring harness.
Installation
1. See Figure 2. Mate the heated seat connector half to the power connector half of the wiring harness.
2. Place seat on frame backbone.
3. To protect finish of Tour-Pak, cover rear seat mounting bracket with palm of hand.
4. While raising rear of seat, use other hand to firmly push front of seat downward and forward until tongue engages slot in seat.
5. Push seat rearward until seat retention nut is centered in hole of mounting bracket.
6. Install seat mounting screw. Hand tighten mounting screw.
7. Pull up on the front and rear of seat to verify that it is properly secured.
Figure 1. Seat Tongue
1Connector
2Mounting slot
Figure 2. Seat Mounting Slot