1.	See Figure 1. Insert coin in notch. Carefully twist until the lens cap pops out of the lamp housing.
2.	While pushing bulb in, rotate counterclockwise to remove.
3.	Inspect condition of electrical contacts in socket. If necessary, clean with a small wire brush and electrical contact cleaner.
4.	Apply ELECTRICAL CONTACT LUBRICANT to contacts in socket and at bottom of new bulb.
5.	Align pins on new bulb with guides in bulb socket. Push and rotate new bulb clockwise into socket.
6.	Snap lens cap onto the lamp housing with notch at bottom.
	WARNING Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)
7.	Check operation of all lamps.

Figure 1. Lens Cap Notch