NOTE
LED headlamps contain no replacement bulbs. Replace the entire assembly if failure occurs. See a Harley-Davidson dealer.
Removal
1. See Figure 1. Remove screw (1). Remove trim ring (2) from lamp housing.
2. Remove headlamp bulb assembly and nesting ring.
3. Disconnect connector from headlamp.
Installation
1. See Figure 1. Place nesting ring (4) on back of new bulb (3) with the index tab facing away from bulb.
2. Mate connector to bulb.
3. Install bulb assembly.
4. Engage index tab of nesting ring with slot at bottom of lamp housing.
5. Engage index tabs on bulb assembly with slots in nesting ring.
6. Install trim ring on lamp housing with screw centered at bottom. Tighten.
Torque: 1–1.6 N·m (9–14 in-lbs) Headlamp ring screw, HDI
7. Check headlamp alignment. See Service Procedures → Headlamp Alignment: Dual LED.
1Screw
2Ring
3Headlamp bulb
4Nesting ring
Figure 1. Headlamp Assembly