Fuses
See Figure 1. The fuse block is under the motorcycle's left side cover, behind the electrical panel cover. The block contains replaceable fuses.
NOTE
See Figure 1. Spare fuses are inserted into slots 7 and 8 in the fuse block. Automotive type ATO fuses are used for replacements.
Fuse Replacement
| 1. | Place the ignition/headlamp key switch in the OFF position. | |
| 2. | Gently pull left side cover from frame. (No tools are required for this step.) | |
| 3. | See Figure 1. Remove the fuse and inspect the element. | |
NOTICE Always use replacement fuses that are of the correct type and amperage rating. Use of incorrect fuses can result in damage to electrical systems. (00222a) | ||
| 4. | Align studs in side cover with grommets in frame and firmly push the side cover into place. |
| 1 | Start relay |
| 2 | System relay |
| 3 | Main fuse (40 amp) |
| 4 | ECM module (15 amp) |
| 5 | Fuel pump (15 amp) |
| 6 | Blank (HDI: Engine Control Fuse) |
| 7 | Spare (15 amp) |
| 8 | Spare (15 amp) |
| 9 | Customer accessory (15 amp) |
| 10 | P&A ignition (2 amp max) |
| 11 | Battery (15 amp) |
| 12 | Accessories (15 amp) |
| 13 | Instruments (15 amp) |
| 14 | Ignition (15 amp) |
| 15 | Lamps (15 amp) |
Figure 1. Fuse Block: 2009 Dyna Models
Replacing the Main Fuse
See Figure 2. All Dyna models have a main fuse to protect the motorcycle wiring. This 40-amp main fuse provides main battery power to the motorcycle. It is located in the fuse holder behind the motorcycle's left side cover.
- Gently pull left side cover from frame. (No tools are required for this step.)
- Grasp and pull the main fuse straight out of the fuse holder.
- Insert the prongs of the new main fuse in the fuse holder slots.
- Align studs in side cover with grommets in frame and firmly push the side cover into place.
Figure 2. Main Fuse