Removal
- See Figure 1. Remove screw and detach seat mounting bracket from top of rear fender.
- Raise seat and remove nut and washer from seat straps.
- Slide seat to the rear of the motorcycle and lift seat.
- It is not necessary to remove the seat bracket and its fasteners from the seat pan.
NOTE
The straps are secured to the fender under the seat by a nut and washer.
Installation
| 1. | Place seat on frame backbone. NOTE There is a tab at the front of the seat that slips under the rear fuel tank mount. | |
| 2. | Slide seat toward front of motorcycle until the tab locks under the fuel tank mount. | |
| 3. | See Figure 1. Push seat forward until rear fender seat retention nut is centered in hole of mounting bracket. | |
| 4. | Install washer and nut to secure seat straps. | |
| 5. | Install screw and bracket to fender. | |
 WARNINGAfter installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
| 6. | Pull up on seat to verify that it is properly secured. |
| 1 | Screw |
| 2 | Seat strap |
| 3 | Seat |
Figure 1. Seat (typical)