System Fuse Removal
NOTICE
Do not skip any steps for fuse replacement. Skipping fuse replacement steps can result in damage to the sound system and/or other motorcycle systems. (00223a)
Fuses are located under left side cover.
For electrical problems, it is best to see a Harley-Davidson dealer who has necessary parts and equipment to perform electrical services.
NOTE
Removal of side covers during electrical service requires no tools. Gently pull side cover to remove. Align barbed studs on side cover with grommets in frame and push to install.
| 1. | Place the ignition/headlamp key switch in the OFF position. | |
| 2. | Remove left saddlebag and side cover. | |
| 3. | Press latch on bottom of fuse block cover and swing bottom of the cover out. Remove the cover. NOTE The fuse block cover has a fuse puller attachment that may be used to remove fuses. | |
| 4. | See Figure 1 and refer to Table 1. Remove fuse and inspect the element. | |
NOTICE Always use replacement fuses that are of the correct type and amperage rating. Use of incorrect fuses can result in damage to electrical systems. (00222a) | ||
| 5. | Replace the fuse if the element is burned or broken. NOTE Automotive type ATO fuses are used for replacements. Two spare fuses can be found in the fuse block. | |
| 6. | Insert the top of the fuse block cover in upper retainer and press bottom of cover to snap into place. | |
| 7. | Install left side cover and saddlebag. |
Figure 1. Fuses: FLHTCUSE3
Table 1. Fuses: FLHTCUSE3
ITEM | FUSE | ITEM | FUSE | ITEM | FUSE | ITEM | FUSE |
|---|---|---|---|---|---|---|---|
1 | Brake (15 amp) | 2 | Accessory (15 amp) | 3 | P&A (15 amp) | 4 | Radio power (15 amp) |
5 | Radio memory (15 amp) | 6 | Battery (15 amp) | 7 | ECM power (15 amp) | 8 | Power lock (15 amp) |
9 | Fuel pump (15 amp) | 10 | System relay | 11 | Start relay | 12 | P&A ignition (2A max) |
13 | Instruments (15 amp) | 14 | Ignition (15 amp) | 15 | Engine control (15 amp) | 16 | Brake relay |
17 | Headlamp (15 amp) | 18 | Lights (15 amp) | 19 | Spare (5 amp) | 20 | Heated grips (5 amp) |
21 | Spare (15 amp) | 22 | ABS (30 amp) | 23 | Amplifier (30 amp) | 24 | Spare (30 amp) |
Maxi-Fuse
See Figure 2. A 40 amp maxi-fuse is located at the right side of the fuse block. The maxi-fuse protects the electrical components in the vehicle.
NOTE
Removal of the maxi-fuse will disable all systems except the starter motor/solenoid.
Figure 2. Maxi-Fuse