Fuses
The fuse block is below the seat and behind the battery. The block contains eight 15-amp replaceable fuses. Additional spare fuses may be carried if the rider chooses to do so.
Fuse Removal
| 1. | Remove seat. | |
 WARNINGTo prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) | ||
| 2. | Disconnect and remove battery negative (-) cable (black) from battery negative (-) terminal. | |
| 3. | Pull cover away from fuse block. | |
NOTICE Always use replacement fuses that are of the correct type and amperage rating. Use of incorrect fuses can result in damage to electrical systems. (00222a) | ||
| 4. | See Figure 1. Replace suspect fuse. |
Fuse Installation
| 1. | Place cover over fuse block. | |
| 2. | Install battery negative cable (black) to battery negative (-) terminal. | |
| 3. | Tighten fastener to 6.8–10.8 N·m (60–96 in-lbs). | |
| WARNING After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
| 4. | Install seat. |
| 1 | Instruments fuse |
| 2 | Ignition fuse |
| 3 | Lights fuse |
| 4 | P&A (2 Amp max) |
| 5 | Battery fuse |
| 6 | Accessories fuse |
| 7 | ECM fuse |
| 8 | Engine control fuse |
| 9 | Headlamp fuse |
| 10 | Spare 15 Amp |
| 11 | Spare 15 Amp |
| 12 | Fuel pump fuse |
| 13 | System Relay |
| 14 | Starter Relay |
Figure 1. Relay/Fuse Panel (Top View)
Maxi-Fuse
See Figure 2. The Maxi-Fuse provides main power from the battery and protects the motorcycle wiring. This 40-amp fuse is located under the seat.
Figure 2. Maxi-Fuse