| 1. | See Figure 1. Position rear wire harness. | |
| 2. | Install anchored cable straps (3). | |
| 3. | Install P-clamp (1). a. Position P-clamp on rear wire harness. b. Install screw (2). Tighten. Torque: 5–7 N·m (44–62 in-lbs) Wire harness, rear, P-clamp screw |
| 1 | P-clamp |
| 2 | Screw |
| 3 | Anchored cable strap (3) |
Figure 1. Rear Wire Harness