Special Tools
| Description | Part Number | Qty. |
|---|---|---|
| WHEEL BEARING INSTALLER/REMOVER | HD-44060 | 1 |
| CRANKCASE BEARING REMOVER ADAPTER | HD-46663 | 1 |
| BALANCE SHAFT SUPPORT BEARING REMOVER/INSTALLER | HD-48474 | 1 |
| KEYWAY PROTECTOR | HD-52795 | 1 |
Output Shaft
| 1. | See Figure 2. Install drive ring gear. a. Install drive ring gear (2), shims (3a, b, c) and spacer (4). NOTE Replace shims as needed. b. Install output shaft (13) with key (1). | |
| 2. | Install new seal (7). | |
| 3. | Install new O-ring. a. Lubricate O-ring (5) with fresh transmission oil. b. Install new O-ring (6) into collar (5). | |
| 4. | See Figure 1. Install collar. a. Install keyway protector (2) to output shaft (3) using special tools. b. Lubricate O-ring (5) inside the collar with fresh transmission oil. c. Install collar (1) on output shaft (3). Special Tool: KEYWAY PROTECTOR (HD-52795) |
| 1 | Collar |
| 2 | Keyway protector |
| 3 | Output shaft |
Figure 1. Keyway Protector
Bearings
NOTE
Lubricate bearings with fresh transmission fluid before installation.
Left Side
| 1. | NOTE If damaged, replace circlip (11). Special Tool: WHEEL BEARING INSTALLER/REMOVER (HD-44060) Special Tool: CRANKCASE BEARING REMOVER ADAPTER (HD-46663) Special Tool: BALANCE SHAFT SUPPORT BEARING REMOVER/INSTALLER (HD-48474) |
Right Side
| 1. | Install roller bearing (9) using special tools. Special Tool: WHEEL BEARING INSTALLER/REMOVER (HD-44060) Special Tool: CRANKCASE BEARING REMOVER ADAPTER (HD-46663) | |
| 2. | Install retaining ring (8). |
| 1 | Key |
| 2 | Drive ring gear |
| 3a | Shim 0.076 mm thick |
| 3b | Shim 0.127 mm thick |
| 3c | Shim 0.254 mm thick |
| 4 | Spacer |
| 5 | Collar |
| 6 | O-ring |
| 7 | Seal |
| 8 | Retaining ring |
| 9 | Roller bearing |
| 10 | Transmission assembly |
| 11 | Circlip |
| 12 | Needle bearing |
| 13 | Output shaft |
Figure 2. Output Shaft and Bearings