1.	Install seal cap at end of TGS. NOTE See Figure 3. The seal cap protects the TGS terminals from dirt and moisture. It also serves as a retention device for the throttle grip. a. Check condition of O-ring on seal cap, replace if necessary. b. See Figure 3. Install seal cap engaging legs in slots at end of TGS.
2.	Install TGS. a. Attach chaser wire used during removal to new TGS connector. b. Draw harness into handlebar while guiding TGS into end into end of handlebar. c. See Figure 4. Verify TGS is engaged into alignment slots in handlebar.
3.	See Figure 1. Connect TGS connector (4).
4.	See Figure 2. Install new cable strap (1).

1	GND 1
2	GND 2
3	Front hand control modules
4	TGS
5	Fork lock
6	Headlamp
7	Front turn signals
8	Heated hand grips

Figure 1. Connectors

1	Anchored cable strap
2	Cable strap

Figure 2. Cable Straps

Figure 3. Install Seal Cap (Models without heated grips)

Figure 4. Install Twist Grip Sensor