1. Install new wire harness.
a. Attach chaser wires to new harness.
b. Install new harness.
c. Remove chaser wires.
2. See Figure 3. Connect connectors:
a. Front jumper harness (3).
b. Headlamp (4).
c. Fork lock (5).
d. Front turn signals (6).
3. See Figure 2. Install new cable strap (2) to left hand turn signal harness.
4. Install new anchored cable strap (1).
5. See Figure 1. Install Universal Serial Bus Type-C (USB-C) nut. Tighten.
Torque: 0.83–1.03 N·m (7.3–9.1 in-lbs) USB-C nut
Figure 1. USB-C Nut
1Anchored cable strap
2Cable strap
Figure 2. Cable Straps
1Anchored cable strap (1)
2Cable strap (2)
3Front jumper harness connector
4Headlamp connector
5Fork lock connector
6Front turn signals connector
Figure 3. Connectors