| 1. | See Figure 2. If necessary, install axle adjuster (2) and adjuster nut (1) (one each side). | |
| 2. | See Figure 1. Install swingarm (3), install LH swingarm bearing cap (2) and screws (1). | |
| 3. | Route WSS wire (5) and install new cable straps (4). | |
| 4. | See Figure 2. Install RH swingarm bearing cap (4) screws (5) and swingarm. Tighten. Torque: 37.5–41.5 N·m (28–31 ft-lbs) Swingarm cap screws |
| 1 | Swingarm cap screws (2) |
| 2 | Bearing cap |
| 3 | Swingarm |
| 4 | Cable straps (5) |
| 5 | Rear lamp wire |
Figure 1. LH Swingarm
| 1 | Adjuster nut |
| 2 | Axle adjuster |
| 3 | Swingarm |
| 4 | Bearing cap |
| 5 | Swingarm cap screws (2) |
Figure 2. RH Swingam