Prepare

1.

Drain coolant. See Cooling System → COOLANT.

Remove

1.	See Figure 1. Reposition clamps (1).
2.	Remove hose (2).

Install

1.	See Figure 1. Install hose (2).
2.	Reposition clamps (1).

1	Clamp (2)
2	Hose

Figure 1. Hose, Coolant Pump to Motor

Motor Inlet Coolant Fitting

Remove

NOTE

Do not replace fitting unless necessary.

1.	See Figure 2. Remove screw (3).
2.	Remove fitting (2).

Install

1.	See Figure 2. Inspect o-ring (1), replace as necessary.
2.	Apply light coating of coolant to o-ring, install fitting (2).
3.	Install screw (2). Tighten. Torque: 4.4–5.2 N·m (39–46 in-lbs) Coolant fitting screw, motor inlet

1	O-ring
2	Coolant fitting
3	Screw

Figure 2. Coolant Fitting, Pump to Motor

Complete

1.

Fill coolant. See Cooling System → COOLANT.