1. See Figure 2. Install LHCM (3) on handlebar (2).
a. Slide LHCM (3) onto handlebar (2) until locator (4) locks in hole.
b. Tighten screw (5).
Torque: 6.3–7.7 N·m (56–68 in-lbs) LHCM screw
c. Install connector (1).
2. See Figure 1. Install front housing.
a. Align switch housing on LHCM.
b. Install screws (5). Tighten.
Torque: 0.6–0.9 N·m (5–8 in-lbs) Switch housing (LHCM) screws.
1Screws
2Front housing
Figure 1. Hand Control Module (Typical)
1Connector latch
2Handlebar
3LHCM
4Locator
5Screw
Figure 2. LHCM Connector (Typical)